Simplifies the complicated design process involved in creating effective voice
networks.
Support both traditional circuit switching techniques and Voice over IP.
Eftekhar - 17 Jul 2009
Active alarm message show
L1 loss framing
L2 awaiting establish
configure for e1
compander type A-law
isdn signalling protocol PRI ETSI
Pls help me
and hoe can i able to active anothe digital interface(3,4) in quintum Dx 2030.
Mikevoip to Shem - 4 Jul 2009
it is found under the di 1 area as defined in the CLI reference guide.
Mike
Shem - 23 Jun 2009
How do I change M-Law to A- Law on a Quintum DX2030?
Abu Sayed - 11 Apr 2009
Hello Sir, I need Tenor DX2030 configuration system. It's very much important to me and I need that configuration method immediately. Please help me on this.
rusel - 19 Aug 2007
Dear sir,
This is rusel from bangladesh. Sir i need DX2030 Quintum configration system. Plz mail me all over the soloution & how to config. IT.
Regards
rusel
Mariush - 27 Sep 2006
Hello
I have got problem with 'Quintum Tenor DX 2030' configuration.
I have pluged gate into LAN (using LAN1 port), so now I can access it using 'Tenor Configuration Maneger'.
But when I'm pluging 'PORT 1' into ISDN device, the 'PORT 1 LED' is still off. I've checked the cable (I'm using 'RJ-45 to RJ-45 straight through cable') and it's OK.
'Digital interface 1' on 'DS1' settings are as follows:
Line type: E1
Port number: 1
Compander type: A-law
Line code: HDB3
Enable CRC: off
All chanels are assignment.
I'm using BRI/(BRA) ISDN access.
So the main question is why the 'PORT 1 LED' is still off, when the gate is plug into ISDN device and what does it mean ???
Post a reply to this article
Posts to this forum are charged at 4.95 Pounds Sterling per article or
reply.
